Introduction to Testing of VLSI Circuits & Fault Modeling Using DSCH 3.5
Free tutorial
4.7
Created by Mrunal Marathe
English
English [Auto]
What you’ll learn
- Introduction to Testing, Principle of Testing, Empirical Rule
- Levels of Fault Modeling, Stuck at Faults
- Introduction to Simulation and DSCH 3.5 Software
- Conversion of DSCH file to Microwind file
- Implementation of AND gate and its fault analysis in DSCH 3.5 software
- Implementation of Half Adder and Full Adder and their fault analysis in DSCH 3.5 software
Requirements
- Basic Concepts of VLSI ,Knowledge of Logic Gates
Description
Welcome to this course, this course is about understanding of Testing and Verification of VLSI Circuits.
This course will not only give you theoretical understanding of Testing concepts but I am sure it will improve your confidence in designing and Fault Modeling analysis of VLSI Circuits.
This course will definitely boost your interest in VLSI Domain.
You will learn following concepts on this course
Introduction to Testing, Difference between testing and verification , Principle of Testing, Benefits of Testing , Types of Testing , Empirical Rule.
Concepts of Defect, Fault and Error, Levels of Fault Modeling, Types of faults, How we can calculate Single Stuck at Faults and Multiple Stuck At Faults of different circuit.
Introduction to Simulation and DSCH 3.5 Software.
Conversion of DSCH file to Microwind file.
Implementation of AND gate and its fault analysis in DSCH 3.5 software.
Implementation of Half Adder and Full Adder and their fault analysis in DSCH 3.5 software.
After completing this course you will be able to design and simulate circuits and also will able to do fault analysis.
We are going to use DSCH 3.5 and Microwind Software for implementing circuits.
After completing this course you will be able to design and simulate circuits and also will able to do fault analysis.
I wish you all the best for course.
Who this course is for:
- First to Last year engineering students
- Class 10th , 11th and 12th students
Show less
Course content
3 sections • 7 lectures • 1h 29m total lengthCollapse all sections
Testing Philosophy2 lectures • 19min
- Introduction to Testing09:42
- Types of Testing08:49
Fault Modeling1 lecture • 14min
- What is Fault Modeling?14:01
Implementation of Different Circuits in DSCH 3.5 Software & Fault Analysis4 lectures • 57min
- Introduction to Simulation and DSCH 3.5 Software03:38
- Implementation of Inverter Gate in DSCH 3.5 and its conversion to Microwind File11:29
- Implementation of AND Gate in DSCH 3.5 and Calculation of Stuck At Faults14:36
- Implementation of Half Adder and Full Adder in DSCH 3.527:02
